High Performance Ignition Leads by FormulaPower
English  

Fitting Instructions

Fitting Instructions

If handled carefully, your new  HIGH ENERGY  Forrmula Power  leads, should last for years. Only fit new leads when engine is cold.

  • Replace leads one by one.
  • When pushing in the ends, please make sure they are at the right angle and pushed in securely. You should hear a click and feel firm.
  • When removing leads,  do not pull them out hold holding the cable.  Hold the boot and give them a slight twist first before pulling them out.
  • Removing cables is best done when leads are cool, rather than hot.
  • To check cables are fitted properly, run the car a few miles and then re check, in case any boots have come loose from not being connected properly.
  • Please make sure that around the spark plug area is clean from oil etc, before fitting.
  • When the cable is warm, you can usually fit them into clips, otherwise we sell cable spacers.

Please email enquiries@formulapower.com or telephone 0208 8969172
with any questions or help needed.




https://www.bestpartstore.co.uk/

Have you seen ...

Aston Martin Banner

Testimonials

Jaguar, V12, XJS

Comment: I DID APPRECIATE GETTING A CHOICE IN COLOURS,AS MY CAR IS BRIGHT RED,AND BLUE LEADS WOULD HAVE LOOKED OUT OF PLACE,ALTHOUGH THIS WOULD NOT...
Read More ->


Lancia Delta 1,Turbo

Très sérieux, je recommande aux autres
Read More ->


Vauxhall Carlton, 24V

Pros: Excellent leads and at a very acceptable price. With a new distributor cap and rotor arm the car now flies. What an improvement in...
Read More ->


Golf 3, Passat, Corrado, VR6

Matriel OK
Read More ->


1985 Series 3, 4.2 litre Jaguar

today I fitted a set of your 10mm Performance HT Leads to my car. They're very well made, they look great and I immediately noticed that a small but...
Read More ->


Languages

English  

Who's Online

There currently are 19 guests online.