Seat Leon, 1.4, 1.6. 16v. (1m1). Formula Power 10mm Race Performance Ht Leads

£69.95

IMPROVING ENGINE EFFICIENCY SINCE 1988.

FORMULA POWER 10mm RACE QUALITY LEADS.

Delivers Stronger Spark to Where its Needed.

Buy now and don't miss out.

TO FIT

Seat Leon, 1.4 inj, 16v. 99>    Leon, 1.6 inj, 16v, 00>   (1M1)
Seat Toledo, 1.4,inj 16v, 99>        1.6 inj, 16v 00>   (1M2)
Seat Inca, 1.4 inj, 16v, 00>  6K9
Skoda Fabia, 1.4. 16v 99>  (6Y2.  6Y3.  6Y5)
Skoda Octavia. 1.4 inj, 16v. 00>04.  (1U2.  1U5)
See above for other compatible models.
RED, BLUE or BLACK CABLE

PLEASE CHOOSE COLOUR YOU WANT WHEN PAYING VIA PAYPAL IN MESSAGE BOX. EITHER RED, BLACK or BLUE. OTHERWISE WE WILL SEND COLOUR WE HAVE IN STOCK. CABLE IS ALL 10mm RACE PERFORMANCE CABLE.

Quote FP 744 when ordering.

Custom engines our speciality.

Very Low Resistance 

Extreme Insulation in excess of 50Kv

Stainless steel wire wound conduit for longevity

High Temp Silicone Plug Boots.

                             Extract from” AM QUARTELY” The Aston Martin club magazine.

The Ultimate cable for spark efficiency for the Aston range, Formula Power, is specially designed for racing and extreme conditions, operating from

-60 to 400 degrees and capable of carrying up to 90,000 Volts.

 A typical energy drop is an amazing 1-2% compared to standard cable of 15-18%.

Particularly good with LPG Conversions

YOU WILL NOT FIND BETTER QUALITY LEADS FOR THE PRICE

Made to BS:EN:ISO 3808 STANDARD

When Purchasing, Please state make model year etc.

 FULL MONEY BACK GUARANTEE, IF YOU ARE NOT TOTALLY SATISFIED.

SAVES FUEL-LOWERS EMISSIONS-LEADED TO UNLEADED CONVERSION.

STOPS FUEL GOING STALE/GUMMING DURING STORAGE.

Catalytic Octane Booster

If you have any questions about this item, or any other item we sell on Ebay, 

please don't hesitate to call between 8am-8pm GMT. Tel 0044(0)208 8969172.

All sets sent registered mail, so it can be tracked.

IMPROVING ENGINE EFFICIENCY SINCE 1988.

FORMULA POWER 10mm RACE QUALITY LEADS.

Delivers Stronger Spark to Where its Needed.

Buy now and don't miss out.

TO FIT

Seat Leon, 1.4 inj, 16v. 99>    Leon, 1.6 inj, 16v, 00>   (1M1)
Seat Toledo, 1.4,inj 16v, 99>        1.6 inj, 16v 00>   (1M2)
Seat Inca, 1.4 inj, 16v, 00>  6K9
Skoda Fabia, 1.4. 16v 99>  (6Y2.  6Y3.  6Y5)
Skoda Octavia. 1.4 inj, 16v. 00>04.  (1U2.  1U5)
See above for other compatible models.
RED, BLUE or BLACK CABLE

PLEASE CHOOSE COLOUR YOU WANT WHEN PAYING VIA PAYPAL IN MESSAGE BOX. EITHER RED, BLACK or BLUE. OTHERWISE WE WILL SEND COLOUR WE HAVE IN STOCK. CABLE IS ALL 10mm RACE PERFORMANCE CABLE.

Quote FP 744 when ordering.

Custom engines our speciality.

Very Low Resistance 

Extreme Insulation in excess of 50Kv

Stainless steel wire wound conduit for longevity

High Temp Silicone Plug Boots.

                             Extract from” AM QUARTELY” The Aston Martin club magazine.

The Ultimate cable for spark efficiency for the Aston range, Formula Power, is specially designed for racing and extreme conditions, operating from

-60 to 400 degrees and capable of carrying up to 90,000 Volts.

 A typical energy drop is an amazing 1-2% compared to standard cable of 15-18%.

Particularly good with LPG Conversions

YOU WILL NOT FIND BETTER QUALITY LEADS FOR THE PRICE

Made to BS:EN:ISO 3808 STANDARD

When Purchasing, Please state make model year etc.

 FULL MONEY BACK GUARANTEE, IF YOU ARE NOT TOTALLY SATISFIED.

SAVES FUEL-LOWERS EMISSIONS-LEADED TO UNLEADED CONVERSION.

STOPS FUEL GOING STALE/GUMMING DURING STORAGE.

Catalytic Octane Booster

If you have any questions about this item, or any other item we sell on Ebay, 

please don't hesitate to call between 8am-8pm GMT. Tel 0044(0)208 8969172.

All sets sent registered mail, so it can be tracked.

SKU: 181434735204

Upgrade for improved performance and stronger spark.

Our 10mm High Energy Formula Power Race Quality

Leads are individually made to measure for your car, so no need to cut leads to size.

  • Extreme insulation property-well in excess of 50KV
  • Very low resistance, which gives excellent spark quality.
  • The centre is kevlar, wound by stainless steel, 70 windings per millimetre
  • , and will carry up to 90,000 volts with an engine compartment temperature of up to 400°C
  • EPDM silicone inner insulation.
  • High temp silicone plug boots with grip ribs.
  • Oil, Ozone,fuel and heat resistant.
  • Specific OHM resistance for hotter spark at plug.

Please contact us for prices.

IF YOU DO NOT SEE THE SET YOU WANT,

PLEASE SEND US DETAIL OF THE MAKE, MODEL,

YEAR ETC. CUSTOMISED ENGINES A SPECIALITY.

If handled carefully, your new HIGH ENERGY Formula Power leads, should last for years. Only fit new leads when engine is cold.

  • Replace leads one by one.
  • When pushing in the ends, please make sure they are at the right angle and pushed in securely. You should hear a click and feel firm.
  • When removing leads, do not pull them out hold holding the cable. Hold the boot and give them a slight twist first before pulling them out.
  • Removing cables is best done when leads are cool, rather than hot.
  • To check cables are fitted properly, run the car a few miles and then re check, in case any boots have come loose from not being connected properly.
  • Please make sure that around the spark plug area is clean from oil etc, before fitting.
  • When the cable is warm, you can usually fit them into clips, otherwise we sell cable spacers.

Will usually dispatch within 3 working days of receiving cleared payment. I must receive cleared payment within 3 days of the auction finishing; otherwise I will report to E-bay and leave negative feedback accordingly.

I always keep proof of posting receipts so if your item gets lost in the post i will send you this receipt so you can claim from the royal mail directly. I will back you up in such a claim and if for any reason you are not 100% happy with your purchase please just contact me and i will be more than happy to sort your problems out thank you

CANCELLATION AND RETURNS (taken from our Conditions of Use)

8.1 The Buyer may cancel the order for any reason up to the point of dispatch and any payments made by the Buyer shall be refunded in full within 28 days. In addition, if you are not satisfied with your new Formula Power HT leads, they can be returned within 30 days for a full refund.

8.2 The Buyer shall inspect the Goods immediately upon receipt and shall notify the Seller via email at websales@formulapower.com within 7 days if the Goods are damaged or do not comply with any of the Contract. If the Buyer fails to do so the Buyer shall be deemed to have accepted the Goods.

8.3 Where a claim of defect or damage is made, the Goods shall be returned by the Buyer to the Seller within 28 days of delivery. The Buyer shall be entitled to a replacement or a full refund (including delivery costs) plus any return postal charges if the Goods are in fact defective.

8.4 If you are a consumer you have the right, in addition to your other rights, to cancel the Contract and receive a refund by informing the Seller via email at websales@formulapower.com within 7 working days of receipt of the Goods.

8.5 Goods must be returned by the Buyer at the Buyer’s expense within 28 days of cancellation in the original packaging and should be adequately insured during the return journey. The Buyer will receive a refund of all monies paid for the Goods (including delivery charges, if any) except for return postal charges. If the Buyer fails to return the Goods following cancellation, the Seller shall be entitled to deduct the cost of recovering the Goods from the Buyer.

8.6 Goods to be returned must clearly show the order number obtained from the Seller on the package.

8.7 Where returned Goods are found to be damaged due to the Buyer’s fault the Buyer will be liable for the cost of remedying such damage.

8.8 Subject to any specific warranties we offer in relation to particular products, or those which are implied by law, we do not offer any warranty or guarantee on our products.

8.9 Our ignition leads are guaranteed for 10 years, as long as no fault can be attributed to customers mishandling or incorrectly fitting the leads. All returns will be examined by our factory before a replacement can be made.